Ironwood-electronics Probe Board With GHZ BGA Socket Assembly Instructi Uživatelský manuál stáhnout pdf

Socket Base

Filename: GPI.mcd, Rev A, 1/18/00, IP

Socket

Top Assembly

Compression Screw

Compression plate

BGA Package

Z-Axis Elastomer

Machine Screw

Socket Lid

Ironwood Electronics Probe Board with GHz BGA socket

Probe board

Test Points

Alignment plate

Probe Board with GHZ BGA Socket

Assembly Instructions

Tele: (800) 404-0204

www.ironwoodelectronics.com

1. Place the square piece of elastomer provided into the socket base (rotational and 'side up' orientation are not critical).

2. Adjust the elastomer to sit into the alignment plate cavity.

3. Place BGA package (solder ball side down) into the socket. NOTE: BGA orientation on target PCB is critical.

4. Place the compession plate (if required*) on top of the BGA package.

5. Install the socket top assembly with the hardware provided (four 0-80 screws).

6. Turn the compression screw clockwise, until it makes contact with the compression plate or the BGA package.

7. Turn an additional quarter-turn.

*Ironwood Electronics technical staff will determine (from your package spec) if a compression or alignment plate is required

Assembly Instructions 1

Shrnutí obsahu

Strany 1 - Assembly Instructions

Socket BaseFilename: GPI.mcd, Rev A, 1/18/00, IPSocketTop Assembly Compression ScrewCompression plateBGA PackageZ-Axis ElastomerMachine ScrewSocket Li

Komentáře k této Příručce

Žádné komentáře

Ironwood-electronics Probe Board With GHZ BGA Socket Assembly Instructi Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Ironwood-electronics Probe Board With GHZ BGA Socket Assembly Instructi. Ironwood Electronics Probe Board With GHZ BGA Socket Assembly Instructions User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Hardware Ironwood-electronics Probe Board With GHZ BGA Socket Assembly Instructi